Dacor PCOR30 Manuel d'utilisateur télécharger pdf

Please read all instructions thoroughly before installing the Over the Range Microwave Oven/Hood System. Two

people are recommended to install this product.

If a new electrical outlet is required, its installation should be completed by a qualified electrician before the

Microwave Oven/Hood is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 2.

1 MOUNTING SPACE

This Microwave Oven/Hood requires a mounting space on

a wall as shown in Figure 1. It is designed to be used with

standard 12-inch wall cabinets.

2 WALL CONSTRUCTION

This Microwave Oven/Hood should be mounted against and supported by a flat vertical wall. The wall must be flat for proper

installation. If the wall is not flat, use spacers to fill in the gaps. Wall construction should be a minimum of 2” x 4” wood studding and

3/8” or more thick dry wall or plaster/lath. The mounting surfaces must be capable of supporting weight of 110 pounds—the oven

and contents—AND the weight of all items which would normally be stored in the top cabinet above the unit.

The unit should be attached to a minimum of one 2” x 4” wall stud.

To find the location of the studs, one of the following methods may be used:

A. Use a stud finder, a magnetic device which locates the nails in the stud.

B. Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate stud location.

The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then placing a mark

halfway between the edges. The center of any adjacent studs will normally be 16” or 24” to either side of this mark.

Figure 1

Backsplash

At least 2"

Epicure range - 36" or

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

1Please read all instructions thoroughly before installing the Over the Range Microwave Oven/Hood System. Twopeople are recommended to install this pr

Page 2 - 4 HOOD EXHAUST DUCT

2Figure 2GroundReceptacleOpening forPower Cord4 HOOD EXHAUST DUCTWhen the hood is vented to the outside, a hood exhaust duct is required. All ductwor

Page 3 - 6 INSTALLATION HARDWARE

3• Phillips Screwdriver• Electric Drill• 1/2”, 5/8” and 3/32” Drill Bits• 1-1/2” Wood Bit or Metal Hole Cutter (ifmetal cabinet is used)• Saw to cut e

Page 4 - Figure 5

4Figure 6Figure 7Fan cover bracket7 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION)This Microwave Oven/Hood is designed for adaptation to three

Page 5 - Figure 10

5Figure 8Figure 9Figure 10Exhaust Damper Assembly(C) RECIRCULATING: Non-Vented, Ductless Operation1. Remove and save 6 screws and fan cover bracket as

Page 6 - 8 OVEN INSTALLATION

6Top SideCutting LineFigure 16(A)(B)Figure 15MOUNTING OVEN TO THE WALLUtilization of the carton may make installation easier.1. Place carton upside do

Page 7 - Figure 20 Figure 21

7Figure 173. Place the oven and the carton portions together on the top of the range. See Fig. 17. Slide carton toward backsplash until itstops. Align

Page 8 - OPTIONAL ACCESSORIES

8OPTIONAL ACCESSORIESCHECKLIST FOR INSTALLATION1. Make sure the unit has been installed according to all of the Installation Instructions and the Wall