Installation InstructionsRenaissance® Gas RangePart No. 108531 Rev. CTHIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITIONS OF ANSI Z

8ANTI-TIP BRACKET PLACEMENTDimension RNRP36G RNRP48GA 10 7/8” (27.6 cm) 1 1/2” (3.8 cm)B 22 1/2” (57.2 cm) 22 1/2” (57.2 cm)* Excludes bull nose (see

92. To install the bracket, place it against the wall in the mounting location. Using a drill with a 1/8” diameter drill bit, drill four (4) 1 5/8” d

10Installation InstructionsRemoving the Oven Door WARNING• Do not attempt to disengage the hinge catches with the door(s) removed from the range. The

11Installation InstructionsFinal Installation1. Peel the protective plastic coating off of the range, including the door.2. Measure from the floor t

12Installing the Burner Knobs WARNINGInstalling the range knobs in the wrong position may result in damage to the griddle included with the range. The

13Installation InstructionsCooktop Assembly WARNINGNever attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates re

14Installation InstructionsVerifying Proper OperationBefore operating the range, read the accompanying use and care manual completely. It contains Imp

Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com

Table of ContentsIMPORTANT:• Installer: In the interest of safety and to minimize problems, read these installation instructions completely and caref

1Important Information About Safety InstructionsThe Important Safety Instructions and warnings in this manual are not meant to cover every possible pr

2Important Safety Instructions• Read the accompanying use and care manual before operating this appliance.• Keep packaging materials away from child

3Planning the Installation WARNING• IMPORTANT: Observe all governing codes and ordinances during planning and installation. Contact your local buildi

4Planning the Installation48” (121.9 cm)Front of open doorFront of handleFront edge of bull noseFront panelRear of front panel/oven door28 1/2” (72.4

5Planning the InstallationCabinet Layout• All maximum and minimum dimensions and clearances shown in the diagrams below must be maintained for safe o

6Gas and Electrical Service• The shaded area shown below denotes the location of the gas inlet and the electrical outlet. This is the recommended loc

7Preparing for Installation WARNING• If the gas or electric service provided does not meet the product specifications, do not proceed with the instal