Installation InstructionsPart No. 113713 Rev. ATHIS APPLIANCE WAS TESTED ACCORDING TO THE LATEST EDITIONS OF ANSI Z21.1 AND CSA 1.1, STANDARDS FOR HO
8Preparing for Installation WARNINGIf the home utilities do not meet product specifications, postpone installation. Call the dealer, the gas supplier,
9SCREW-SIZE TABLESub-Floor Type/Floor Covering Thickness Screw SizeConcrete or wood sub-floor, no floor covering#8 x 1*Concrete or wood sub-floor, flo
10Removing the Oven Door WARNING• With the door off the range, do not remove the hinge catches. The springs could release abruptly, causing personal
11Final Installation1. Peel all protective plastic from the range.2. Measure from floor to countertop, and adjust the leveling legs so the cooktop i
12SimmerSear Burner Assembly (left-front burner only)Standard Burner Assembly (left-rear, right-rear, right-front burners)STEP 1: Install burner head.
13Verifying Proper OperationBefore operating the range, read the User Manual completely. It contains important safety, service, and warranty informati
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com
Table of ContentsIMPORTANT• Installer: For safety’s sake and to minimize problems, read this manual thoroughly before beginning the installation. Lea
1Important Info About Safety InstructionsThis manual cannot cover every possible problem and situation that can occur. Use common sense and caution wh
2Important Safety Instructions WARNING• Read the User Manual before operating the range.• Keep packaging away from children. Plastic sheets and bags
3Consignes de Sécurité ImportantesInformations importantes sur les consignes de sécuritéCe manuel ne peut pas couvrir tous les problèmes et situations
4Consignes de Sécurité Importantes ATTENTION• Lisez le manuel d’utilisation ci-joint avant d’utiliser la cuisinière.• Gardez les matériaux d’emballa
5Electrical Requirements WARNING• Observe all codes and ordinances during planning and installation. Contact the local building department for detail
6Product tolerances: ±1/16” (±1.6 mm)Product DimensionsWidth: Range Installed In Cabinetry Cutout Range Installed In Cutout With Downdr
7Note 2FG2 Cabinet/countertop depth is at discretion of customer but cabinet face MUST NOT protrude further than rear of front panel, see product dime
Commentaires sur ces manuels