Dacor CM24P-1 Guide de dépannage télécharger pdf (Page 7)

Dacor Technical Assistance: 800-353-2267

Oven Temperature Calibration Instructions Continued:

ER-Dual Fuel Range Temperature Calibration Procedure

Range Models: ER30D, ER30DSR, ER36D, ER48D

• Press and HOLD Bake Keypad for 10 seconds or until the display changes.

• Using the Number Keypad, enter the new Calibration Offset.

• Use the Self Clean Keypad to select “+” or “-” up to +/-35˚F.

• Press Cancel to lock in new setting. Factory setting is “00”.

Renaissance & Distinctive Wall Oven & Range Temperature Calibration Procedure

Renaissance Wall Oven Models: EORS130, EORS230, EORD230, EORS127, EORS227, EORD227,

MORS130, MORS230, MORD230, MORS127, MORS227, MORD227, RO130, ROV130, RO230, ROV230

Distinctive Wall Oven Models: DO130, DO230

Distinctive Range Models: DR30D, DR30DI

• Press and HOLD the “0” and “#” keypads at the same time. After about 3 seconds, the display will

read: PASS.

• Using the Number Keypad, enter pass code: 6-4-2-8 then press the Start Keypad. The display will

change and read: SLCE “00”.

• Quickly select the cooking mode that needs to be Calibrated. Using the Number Keypad enter the new

Calibration Offset.

• Use the “#” Keypad to select “+” or “-” up to +/-35˚F.

• Press START to lock in new setting. Factory setting is “00”. Press CANCEL to complete procedure.

ER-All Gas Range Temperature Calibration Procedure

Range Models: ER30G, ER30GI, ER36G, ER36GI

• Disconnect Range from Power Supply.

• Pull unit out from wall and remove rear panel of range to access the Relay Board.

• The relay board will have dip-switches mounted near the center of the board.

• Use the chart below to enter Calibration Offset.

• Reassemble Range and restore power.

PG: 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 32 33

Pas de commentaire

Dacor CM24P-1 Guide de dépannage Page 7