Dacor DYF42BNDI Manuel d'utilisateur télécharger pdf

All specications subject to change without notice.

Phone: (800) 793-0093www.dacor.com

PLANNING

GUIDE

DYF42BNDI, DYF48BNDI

Discovery

™

42” and 48” Wide

Built-In Custom Panel Refrigerators

Document # PG11-013

Revised 10/21/13 Page 1/5

¹/2

(212.1 cm) min.

³/4

(215.3 cm) max.

to bottom of solid soffit

(195.6 cm)

(see chart following)

24"

(61.0 cm) Min.

Model Series Cutout Width A Dimension B

DYF42BNDI

41½” (105.4 cm) to

41¾” (106.0 cm)

10”

(25.4 cm)

DYF48BNDI

47½” (120.7 cm) to

47¾” (121.3 cm)

16”

(40.6 cm)

NOTE: Flooring under refrigerator must be at same level as the room. Face

of cabinetwork must be plumb.

See Page 2/5

WARNING

• Observe all governing codes and ordinances during planning

and installation. Contact your local building department for

further information.

• This appliance must be installed in accordance with the

accompanying installation instructions.

Location Requirements

Your Dacor refrigerator can be recessed in an opening between cabinets

or installed at the end of a cabinet run using a side panel to enclose the

refrigerator.

IMPORTANT:

◊ The location must allow the refrigerator to be moved out from the

wall without being disconnected in the event that service become

necessary.

◊ It is recommended that you do not install the refrigerator near an

oven, radiator, or other heat source.

◊ Do not install in a location where the temperature will fall below 55°F

(13°C).

◊ Floor must support the refrigerator weight, more than 600 lbs.

(272 kg), door panels and contents of the refrigerator.

◊ Ceiling height must allow for side tipping radius. See installation

instructions.

◊ Location should permit doors to open fully. See Door Swing

Dimensions.

◊ Location must permit top grille removal. See Opening Dimensions.

◊ A grounded 3 prong electrical outlet should be placed in the area

shown in the diagram on the right. See Electrical Requirements for

more information.

◊ The water shutoff should be located in the base cabinet on either

side of the refrigerator or some other easily accessible area. If the

water shutoff valve is not in the cabinets, the plumbing for the water

line can come through the floor or the back wall. See Water Supply

Requirements for more information.

Opening Dimensions

◊ To avoid tipping during use, the solid soffit must be within 1” (2.5 cm)

maximum above the refrigerator. If the solid soffit is higher than 1”

(2.5 cm) or one is not available, then the refrigerator must be braced.

If the anti-tip boards are needed, they must be attached to the rear

wall studs 80” to 90” (203.2 cm to 228.6 cm) above the floor. See

installation instructions for more information.

NOTE:Aclearanceof¹⁄2” (1.3 cm) must be maintained above the top

grille in order for the top grille to be removed.

1/2” (1.3 cm)

1 2 3 4 5

Résumé du contenu

Page 1 - DYF42BNDI, DYF48BNDI

All specications subject to change without notice.Phone: (800) 793-0093www.dacor.comPLANNINGGUIDEDYF42BNDI, DYF48BNDIDiscovery™ 42” and 48” WideBuilt

Page 2

All specications subject to change without notice.Phone: (800) 793-0093www.dacor.comPLANNINGGUIDEDYF42BNDI, DYF48BNDIDiscovery 42” and 48” WideBuilt-

Page 3

All specications subject to change without notice.Phone: (800) 793-0093www.dacor.comPLANNINGGUIDEDYF42BNDI, DYF48BNDIDiscovery 42” and 48” WideBuilt-

Page 4 - Custom Panels

All specications subject to change without notice.Phone: (800) 793-0093www.dacor.comPLANNINGGUIDEDYF42BNDI, DYF48BNDIDiscovery 42” and 48” WideBuilt-

Page 5 - Discovery 42” and 48” Wide

All specications subject to change without notice.Phone: (800) 793-0093www.dacor.comPLANNINGGUIDEInset Installation Dimensions Measure the distance