Dacor DHICH Manuel d'installation

Installation InstructionsDiscovery™ Island (Ceiling Mount) Range HoodsModels: DHI361, DHI421, DHI482 and DHI542Part No. 101744 Rev. GAPPROVED FOR USE

8Install the Duct Work WARNINGDo not use screws to attach the duct work to the hood exhaust outlet. Use duct tape only. Screws may prevent the damper

9Preparing for InstallationFinal Electrical Installation WARNING• To avoid electric shock or fire hazard, prior to con-necting the electrical wiring

10Installation InstructionsVerifying Proper Operation1. Make sure power is switched on at the circuit breaker panel or fuse box.2. If the control pa

11Wiring DiagramsPlease note—the layout on the PC Board shown above may vary—however all wires are coded and the connections on the PC Board are also

12Wiring DiagramsPlease note—the layout on the PC Board shown above may vary—however all wires are coded and the connections on the PC Board are also

Dacor●14425ClarkAvenue,CityofIndustry,CA91745●Phone:(800)793-0093●Fax:(626)403-3130●www.dacor.com

Installation Instructions ... 5Verify the Package Contents ... 5Instal

1Important Information About Safety Instructions The Important Safety Instructions and warnings in these instructions are not meant to cover all pos

2Important Safety Instructions• If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, pe

3DimensionsTolerances: ±1/16” (±1.6 mm), -0 unless otherwise stated* 18” 1/4 on models DHI482 and DHI542IMPORTANT: The minimum installed distance from

4Planning the Location WARNING• Observe all governing codes and ordinances during planning and installation. Contact your local building department f

5Calculating the Maximum Duct Run LengthThe maximum straight duct length for the hood is 50 feet. To determine the actual maximum duct run, subtract t

6Assemble the Hood1. Place the hood assembly on a soft surface with the bottom side down during assembly to avoid damage.2. Tip the hood up on it’s

76. Separate the bottom framework piece from the top framework piece. The top frame work piece has 5-inch slots on the sides. The bottom piece has a