Dacor HICT305BG Manuel d'installation Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 18
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
10
Verifying Proper Operation
This procedure instructs you how to verify the basic opera-
tion of each cook zone. See the Use and Care Manual to
verify operation of other features.
Use a ferrous (magnetic) pot/pan, and perform this proce-
dure for all cook zones.
IMPORTANT
Before performing this procedure, remove all foreign material
from the cooktop.
As directed in the Use and Care manual, clean the cooking
surface.
1. Turn on power to the cooktop at the circuit-breaker
panel or fuse box.
2. Set a 1/4-full pot of water on a cook zone. (Select a
zone that is appropriate to the size of the pot.)
3. On the main control panel, press the power button.
A red dot appears above the button, indicating that the
cooktop is on.
4. On a cook-zone control panel, press the power button.
The ON indicator appears.
5. Press the left end of the cook-zone slider.
The SIM indicator appears, showing that you selected
Simmer mode.
6. Move your finger back and forth along the slider.
The zone’s digital readout and heat-level ramp change
as your finger passes over a heat level.
7. Stop on a heat level, and remove your finger.
8. When you see that the water is heating as expected,
press the cook-zone power button.
The zone’s ON indicator goes out; the cook zone is off.
WARNING
If the cook zone HOT indicator has appeared, it will stay on until
the cook zone is safe to touch without causing a burn injury.
In testing other cook zones, be careful where you touch the
cooktop surface while any HOT indicators appear.
9. Repeat Steps 4-8 for the other cook zones.
10. On the main control panel, press the power button.
The red dot above the button goes out; the cooktop is
off.
Troubleshooting
If the cooktop does not operate properly:
verify that power is supplied to the cooktop and that all
electrical connections proper and secure.
repeat the Verifying Proper Operation procedure.
If the appliance still does not work, do not try to repair it but
contact Dacor Distinctive Service: (800) 793-0093 x2822.
Have the model/serial numbers available when you call. (If
the numbers are not written in this manual, they are on the
product label on the bottom of the appliance chassis.)
Installation Checklist
The cooktop’s proper installation is critical to its intended
function and user safety.
The installer should review this checklist to ensure the
installation has been properly performed. The homeowner
is ultimately responsible for the cooktop’s proper installa-
tion.
Were all minimum cabinet/countertop clearances met
or exceeded? (Pgs. 5 and 6)
Was the cooktop wired/grounded as instructed and per
electrical codes and ordinances? (Pgs. 3 and 8)
Was the cooktop secured with the provided hold-down
brackets? (Pg. 8)
Was proper operation verified? (Pg. 9)
Was the warranty activated (online or by completing
and mailing the warranty card)?
Were any problems noted on the warranty card or dur-
ing the online warranty activation?
INSTALLATION INSTRUCTIONS
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire