Dacor PCOR30 Manuel d'utilisateur télécharger pdf (Page 4)

Figure 6

Figure 7

Fan cover bracket

7 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION)

This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your

installation.

Vertical Exhaust — outside ventilation. Follow installation procedure (A).

Horizontal Exhaust — outside ventilation. Follow installation procedure (B).

Recirculating — non-vented, ductless. Follow installation procedure (C). Recirculating requires the use of the Charcoal Filter.

(A) VERTICAL EXHAUST: OUTSIDE VENTILATION

The unit is shipped assembled for vertical exhaust. Attach the Exhaust

Damper Assembly to the fan cover on the top of the outercase cabinet by

sliding it into the slits in the same direction as the arrow mark. Using

Tapping Screw 4x12 from the INSTALLATION HARDWARE, tighten into

place. See Fig 5.

(B) HORIZONTAL EXHAUST: OUTSIDE VENTILATION

1. Remove and save 6 screws. Remove fan cover bracket as shown in Fig 6.

2. Withdrawn hood fan unit carefully and slip wires out of wire box. Rotate hood fan unit 90˚ so that exhaust ports are facing rear

of oven unit. See Fig 7.

CAUTION: Do not pull or stretch hood fan wiring.

3. Replace hood fan unit into the oven unit. Be careful not to pinch the lead wire between the inner bracket and the hood fan unit.

See Fig 8.

4. Put the lead wire into wire box.

5. Replace the fan cover bracket. Make sure the fan blades are visible through the rear openings in the oven before proceeding.

Attach fan cover bracket to unit with 6 screws. See Fig 9. The hood fan unit is now rotated for horizontal exhaust operation.

6. Attach the Exhaust Damper Assembly to the back of the mounting plate by sliding it into the slits in the same direction as the

arrow. See Fig 10. Using Tapping Screw 4x12 from the INSTALLATION HARDWARE, tighten into place.

Exhaust Damper Assembly

Figure 5

1 2 3 4 5 6 7 8

Pas de commentaire

Dacor PCOR30 Manuel d'utilisateur Page 4