Dacor PCOR30 Manuel d'utilisateur télécharger pdf (Page 6)

Top Side

Cutting Line

Figure 16

(A)

(B)

Figure 15

MOUNTING OVEN TO THE WALL

Utilization of the carton may make installation easier.

1. Place carton upside down. See Figure 15.

2. Using cutting line around the carton, cut into two pieces (A) and (B). See Figure 16.

Mounting

Plate

Figure 12 Figure 13

Figure 14

Space more than

wall thickness

Wall

8 OVEN INSTALLATION

THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND

ON WALL AND TOP CABINET TEMPLATES.

MOUNTING PLATE

1. Separate 4 Toggle Bolts, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.

2. Use wood screws to attach mounting plate to the stud or studs. Use Toggle Bolts to attach mounting plate through the holes at

A, B, C and D UNLESS THOSE HOLES ARE LOCATED ON THE STUD. Insert one Toggle Bolt into A, B, C and D where

appropriate (these correspond to holes of the Wall Template) and put the Toggle Nuts onto the Toggle Bolts. Figure 12.

Refer to instructions in Wall Template.

3. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts through the

holes in the wall with the Toggle Nuts closed. Figure 13. Use Wood Screws to attach the Mounting Plate to studs.

NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting Plate and the

end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the Toggle Nut will not be able to

open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from the hole; therefore make

sure all of the Toggles are in the correct position before insertion.

4. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you and turn

clockwise to tighten. Figure 14.

1 2 3 4 5 6 7 8

Pas de commentaire

Dacor PCOR30 Manuel d'utilisateur Page 6