Dacor PCOR30 Manuel d'utilisateur télécharger pdf (Page 7)

Figure 17

3. Place the oven and the carton portions together on the top of the range. See Fig. 17. Slide carton toward backsplash until it

stops. Align the lower back edge of the oven with the mounting plate.

4. Thread the power supply cord through the hole made in the bottom of the top cabinet.

5. Hang the oven on the lower edge of the mounting plate. See Fig. 18. Take care that the power cord is able to clear the edge of

the hole as the oven is rotated upward. (In the case of a non-recessed bottom in the top cabinet, the hole for the cord may need

to be enlarged.) Remove the carton portions.

6. Tighten the two unit mounting screws located in the grease filter openings. See Fig.19.

7. Install grease filters by fitting into the opening. Push back and up into place. See Fig.20.

8. Use the two Top Cabinet Screws (C) and two Flat Washers (D), supplied in the INSTALLATION HARDWARE, to attach the unit

to the top cabinet. See Fig.21.

9. Make a bundle of the power supply cord and attach it to the inside of the cabinet using the Power Cord Hanger.

Figure 18

Figure 19

(B)

Figure 20 Figure 21

1 2 3 4 5 6 7 8

Pas de commentaire

Dacor PCOR30 Manuel d'utilisateur Page 7